
Scratches on a Metal Roof: Why Damaged Paint Can Void the Warranty
A scratch on a metal panel looks small, but the paint is what protects the steel. Here is what we found on a recent job and why scratches turn into rust.
On a recent metal roof job, we found scratches all over the panels, left behind by the previous installer. From the ground they are easy to miss. Up close, many of them go through the paint.
The paint is the protection
The warranty on metal roof panels covers rusting and corrosion, and that protection depends on the paint and coating staying intact. Once the paint is compromised, the steel underneath is exposed to water and weather.
- A scratch through the paint lets moisture reach bare metal.
- Rust starts at the scratch and can creep out under the paint around it.
- On a sloped roof, rainwater carries it downhill as rust streaks.
- Damage caused during installation may not be covered by the manufacturer.
How scratches get there
- Walking on panels in the wrong spots or with the wrong footwear.
- Dragging panels, tools, or materials across finished metal.
- Cutting with abrasive blades that throw hot metal onto the paint.
- Leaving metal shavings from screws and cuts to rust on the surface.
Questions to ask before a metal roof install
- How will your crew protect the panels while working on the roof?
- Do you sweep metal shavings off the roof before you leave?
- Will you touch up or replace any panel that gets scratched during the job?
- What does the panel warranty cover, and what voids it?
Treat metal like metal
Gerkin Construction installs and repairs metal and shingle roofs across Lawrence and Orange Counties. If your metal roof is showing scratches or early rust, contact us for a free inspection.
Keep reading
Related guides
RoofingRoof Cement Is Not a Roof Repair: What We Found on a Metal Roof
Pounds of sealant over a metal roof joint can hide a leak for a while, but it does not fix it. Here is what we found on a recent job and what a real repair looks like.
Read the guide
RoofingRidge Vent vs. Soffit Vent: Why We Measure Both Before We Bid
A ridge vent only works if enough air can get in at the bottom. Here is why we measure the ridge opening and size the soffit intake to match it.
Read the guideSee something around your home that does not look right?
Tell us what you are noticing. The Gerkin team can inspect the issue, document what we find, and explain the practical next step.
